Hello all,
Please forgive the newcomer question, but I am just getting started with writing batch script files that utilize Symantec Ghost and am looking for some simple examples. I'm running Win7 and Symantec Ghost 11.5. Basically I am just trying to deploy a give .GHO file to a hard drive. I am setting up the HD such that it will have multilpe partitions. But I am doing the creation of it manually. The deployment is what I am looking to script. These are my two scripts that I would like to accomplish. I have written in steps what I would do manually using the Ghost wizard.
#1 - Deploy Disk Image (contains partition table)
1a. Load Symantec Ghost
1b. Local>Disk>From Image
1c. Y:\\Images\PartitionTable.GHO
1d. Select destination drive
Note: Currently I am using a USB-HD device where I can simply plug it into my PC and run Ghost wizard and select the drive to deploy. Eventually I want to be able to plug a USB stick into a computer, boot from the USB stick (it will run WinPE), and have the batch file deploy the .GHO (which will be stored on a network drive).
#2 - Deploy a Partition Image (obviously done after the Partiition table is deployed)
2a. Load Symantec Ghost
2b. Local>Partition>From Image
2c. Y:\Images\PartitionImage.GHO
2d. Select source partition from image file (Image file will only have one source partition)
2e. Selection destination drive
2f. Select destination partition from Basic drive
Any help would be greatly appreciated. Thanks.